![]() ![]() If you do not have a hub you can use a switch which supports so called port mirroring ( ). In order to capture all the packets which are sent via particular LAN, the devices have to be part of the same network segment (they have to be connected via HUB). Before starting network captureīefore Wireshark (or in general, any packet capture tool) is used, careful consideration should be given to where in the network packets are to be captured. ![]() Wireshark is distributed under the Open source licence ( ). PBX connected with a GSM gateway via LAN) send to each other packets which are captured by the above mentioned program. ![]() Program Wireshark is used for tracing the communication between devices interconnected by LAN. How to get network trace from 2N® StarGate / 2N® BlueTower? How to get Wireshark network trace? This article explains how to perform both network trace in such software called Wireshark as well as network trace directly from gateway. Gateway can provide network tracing with limited size on its side, for unlimited network trace of IP communication, external device (usually laptop or PC) equipped with network capture software needs to be used. If network trace is requested, please note there are two possible network traces available. In order to analyse what this communication between devices contains, a network trace can be requested. Network trace contains whole communication between IP devices over LAN. ![]()
0 Comments
Leave a Reply. |